Strobe Leds Flasher ChangchungLeds. How to connect.
Watching the top of the module flasher with the screws to the left, connections are, to the bottom to top. Check the image
1º Connect to Positive 12 volts, use a switch and 10 amperes fuse in this line. No inclued.
2º Connect to Ground
3º Positive Output Channel 1
4º Negative Output Channel 1
5º Positive Output Channel 2
6º Negative Output Channel 2
The Momentary Push Button Switch is to change the patterns. (No covered by the warranty)
You can use the ground of your vehicule to connect your Leds lights and use less wires. The Ground are internal common.
This unit is solid state and completely waterproof and comes with a 1 year warranty.
SPECIFICATIONS. SUITABLE FOR USE ONLY WITH 12 Volt LEDs.
Input surge protection
Reverse polarity protection
Outputs protection
100% solid-state
Waterproof
3 differents flash patterns selection in 4 groups
Encapsulated Electronics
Can handdle 6 amperes in each output
Do not drill any holes in the unit
Input Voltage 12Vdc (14.4 nominal).
Input Current 10 amperes @ 14.4Vdc
Use a 10 amperes Fuse in the input (automotive type) No inclued.
Made In USA
Check in youtube this video to see the patterns
