Thanks for check my Smart Brake Flash Electronic Module For Leds.
Watching the top of the flasher with the screws to the left, connections are, to the bottom to top. Check the image
1º Connect to 12 volts Positive ACC, Use a 5 amperes fuse in this line (Some motorcycles has the lights always on, you can connect this to the tail light of the same wiring of the taillight light).
2º Connect to Ground (You can use the same ground in the wiring to the taillight light)
3º Brake signal in. (Cut this wire to the taillight brake signal, connect the side coming from the motorcycle here)
4º Output12 volts To the taillight brake (Connect it to other side previously cutted)
5º Tail light 1 30% bright (Cut the wire to the tail light from the bike and connect it here) You will not use the other wire that go the taillight of the motorcycle. (if your bike had the lights always on you can use this wire to power the module).
6º Tail light 2 50% bright (Jump here the taillight if you want the parking light brighter).
7º use both taillights input to increase to approx 70% of brightness for the parking lights. Remember that the same output will provide parking light and brake to the Led.
To change the preset on the module you need to press the brake 10 times before 5 seconds. The brake light will flash the times of the funtion.
1º Function; Stock.
2º Function; Will flash 4 times when the brake is press and stay on until release the brake.
3º Function; Will flash 4 times when the brake is press, the light will stay on for 5 sec and flash 4 times again and continue until release the brake.
4º Function; Will flash 4 times when the brake is press keep it on for 5 sec and flash 4 times again and go on until release the brake. Will flash 4 times each 9 sec without press the brake.
5º Function; Will flash 4 times when the brake is press stay on for 5 sec and flash 4 times again and go on until release the brake. Will flash 4 times each 1 sec without press the brake.
This unit is solid state and completely waterproof
SPECIFICATIONS. SUITABLE FOR USE ONLY WITH 12 Volt LEDs.
Input surge protection
Reverse polarity protection
Output protection
100% solid-state
Waterproof
Encapsulated Electronics
Can handdle 6 amperes
Do not drill any holes in the unit
Input Voltage 12Vdc (14.4 nominal).
Input Current 5 amperes @ 14.4Vdc
Use a 5 amperes Fuse in the input (automotive type) no included.
Here a video
